idaho falls generac

Generac Generators in Idaho Falls, Idaho

Standby generator installation, annual maintenance, repair and Mobile Link monitoring from a Generac certified service dealer based on E Piper St in Idaho Falls.

Backup Power Built Around How Idaho Falls Lives

When the power drops in Idaho Falls in January, it is not just the lights. Furnace blowers stop, sump pumps go quiet and the freezer starts counting down. A Generac standby generator is wired permanently into your home or business, watches for an outage and starts on its own within moments, so you are not dragging a portable generator through the snow. Sunlight Electric is a Generac certified service dealer based at 1710 E Piper St, Unit P, in Idaho Falls. We install new standby generators, keep existing ones maintained, repair units that are not running right and set up Generac Mobile Link monitoring, all from one local shop.

This page pulls every part of our Generac work for Idaho Falls into one place. For more detail on any single service, see Generac generator installation or Generac generator service and maintenance.

Four Ways We Help Idaho Falls Generator Owners

  • New standby installation for homes, shops and small businesses, from sizing through startup.
  • Annual maintenance that follows Generac's maintenance schedule for your model.
  • Repair and troubleshooting on the generator, the automatic transfer switch and the panel connections.
  • Mobile Link setup so you can check your generator's status from your phone.

Start With a Free In-Home Assessment

Every installation starts with a conversation about what you actually need to keep running. Some Idaho Falls homeowners only want the furnace, refrigerator, well pump and a few lights covered. Others want the whole house to feel normal during an outage. A home business or a shop with freezers and computers has different priorities again. At the assessment we review your electrical service, your fuel options and where the generator can sit, then talk through a sizing recommendation and installation scope. Book a free in-home Generac assessment to get started.

New Standby Generator Installation in Idaho Falls

A standby generator touches several systems at once: your electrical panel, a fuel supply and the ground it sits on. Here is how an Idaho Falls installation usually goes:

  1. Sizing and layout. We match the generator and transfer switch to the loads you chose at the assessment and plan a location that meets clearance requirements.
  2. Permits. Inside city limits, electrical permits go through the City of Idaho Falls online Cityworks portal, and work cannot begin until the permit is issued. We handle that paperwork.
  3. Pad and fuel. The unit is set on a pad and connected to natural gas or propane.
  4. Transfer switch and wiring. Our licensed electricians install the automatic transfer switch and wire it to your panel.
  5. Inspection and startup. We start the unit, test a transfer and walk you through how it works. After that we call for a final inspection and make sure everything passes the city requirements.

Choosing Where the Generator Sits

Placement matters more than most people expect. The unit needs proper clearance from windows, doors and vents, a short and practical route for the gas line and the wiring to the transfer switch, and access for future maintenance. In Idaho Falls neighborhoods with tight side yards, that can take some planning. We also think about drifting snow and where you will actually walk in winter, so the generator is easy to reach for service. We lay out the options at the assessment and confirm the location before anything is ordered.

Backup Power for Idaho Falls Businesses

For a business, an outage can mean spoiled inventory, a dead point-of-sale system or a locked front door. We install standby generators for shops, offices and other small commercial buildings, sized to the circuits that keep you operating, and we maintain them on a schedule that fits your hours. Because we are available 7 AM to 9 PM every day, it is easier to book service without closing early.

Natural Gas or Propane?

Generac standby generators run on natural gas or liquid propane. Intermountain Gas lists Idaho Falls, Ammon, Iona, Ucon, Shelley and Rigby among the communities its Idaho Falls district serves, so many in-town homes can tie into an existing gas line. Rural properties outside the gas network usually run on propane instead. We check your gas service and meter during the assessment and factor the fuel type into sizing and placement.

Annual Maintenance That Keeps It Ready

A generator can sit quietly for months and then be asked to carry your house through a long winter outage. Annual service is what makes that first start reliable. Our technician inspects the generator and transfer switch, follows Generac's maintenance schedule for your model, checks the battery and connections, looks for wear or leaks and runs the unit to confirm it starts and transfers power. If something needs attention, we explain it and give you options before doing any extra work. Fall is a good time to book, before the cold sets in.

Repairs When Something Is Not Right

Is your generator showing a warning, failing its weekly exercise or refusing to start? Because we are licensed electricians as well as a Generac certified service dealer, we troubleshoot both sides of the system: the engine and controller on the generator, and the transfer switch and panel connections on the electrical side. We work on Generac units whether we installed them or not.

Mobile Link Remote Monitoring

Generac Mobile Link shows your generator's status, exercise results and maintenance alerts on your phone. It is especially handy if you travel in winter or own a rental or second property. If your generator supports Mobile Link but was never connected, we can help get it set up.

Your Utility and Your Generator

Inside city limits, homes and businesses get power from Idaho Falls Power, the city's municipal utility. Many neighboring areas, including Ammon, are served by Rocky Mountain Power. Whichever utility you have, a properly installed transfer switch keeps generator power from feeding back onto the utility lines during an outage, which protects line crews working to restore service. That is one of the main reasons a standby generator should be installed by a licensed electrician.

Licensed in Idaho, Local to Idaho Falls

Sunlight Electric has been in business since 2021, and our owner has worked as an electrician since 2002. We hold Idaho Electrical Contractor License #053631 and Idaho Master Electrician License #053181, plus Wyoming contractor and master electrician licenses. See our licenses and insurance or read what customers say on our reviews page.

Generator Service Around Idaho Falls

From our Idaho Falls shop we serve standby generator customers across Bonneville County and nearby: Idaho Falls, Ammon, Iona, Ucon, Shelley, Rigby and Firth.

Ready to talk generators? Call (208) 206-7819 any day from 7 AM to 9 PM, send us a message or request your free in-home assessment.

Click to Get Started

faq

Do I need a permit for a standby generator in Idaho Falls?

Yes. Inside Idaho Falls city limits, a standby generator is electrical work regulated by the City of Idaho Falls, so a permit is required before work starts and the installation is inspected afterward. We pull the permit as part of the job. Outside city limits, we use the permitting authority that covers your address.

Can you service a Generac generator that another company installed?

Yes. We maintain and repair Generac units whether we installed them or not, including the transfer switch and the panel connections on the electrical side.

What happens at the free in-home assessment?

We talk through which circuits you want backed up, look at your electrical service and fuel options, and check where the generator could sit. Then we discuss a sizing recommendation and the proposed installation scope. You can request one on our Generac assessment page.

Service Needed

Thank you for the opportunity to earn your business. Someone from our team will be in contact as soon as possible!

Thank you! Your submission has been received!
Oops! Something went wrong while submitting the form.

Your Future
Electricians

Do you need a project estimate, or simply have some questions for us? Fill out this form, or give us a call. Someone from our team will get back to you as soon as possible. We appreciate the opportunity to earn your business, and look forward to being your future electricians!